Installation Instruction RSEI 106
• Route the actuator wire around the backside of the slider and plug the red/black
connector into the slider
• Actuator wire must be wired around the backside of slider so it’s protected from
the elements and will not be severed off during off-road activity
• Secure wires to minimize slack so they are protected. We recommend zip ties
• *Optional: The pink/tan wire is used if LED light package is being installed
• Inside the Jeep, route the rear passenger door sensor wire along the doorframe; and
using a sticky pad, mount the sensor underneath the door latch
• Connect the blue/white wire to the door sensor
• Place a small piece of electrical tape on the sensor wire to secure (see below)
• While moving to the front passenger door, run the harness along the side of the Jeep’s
tub and route the front passenger door sensor wire up the “B” pillar of passenger door;
and using a sticky pad, mount the sensor underneath the door latch
• Connect the green/grey wire to door sensor
• Place a small piece of electrical tape on the sensor wire to secure
• Returning to the backseat, locate the drain plug on the rear driver side and drill a small
hole into it to allow you to run the actuator wires to the slider
• Once the actuator is run to the slider you can put some silicon sealant around
the drilled hole to prevent any elements from entering, but it’s not required
• Route the actuator wire around the backside of the slider and plug the red/black
connector into the slider
• Actuator wire must be wired around the backside of slider so it’s protected from
the elements and will not be severed off during off-road activity
• Secure wires to minimize slack so they are protected. We recommend zip ties
• *Optional: The brown/tan wire is used if LED light package is being installed
• Route the rear passenger door sensor wire along the doorframe; and using a sticky pad,
mount the sensor underneath the door latch
• Connect the blue/white wire to the door sensor
• Place a small piece of electrical tape on the sensor wire to secure
• Continue to route the harness wires along the lower doorframe on the tub, and just like
performed on the passenger side route the door sensor wire along the “B” pillar up the
doorframe and using another sticky pad, mount the sensor below the door hatch.
• Connect the orange/yellow wire to the door sensor
• Place a small piece of electrical tape on the sensor wire to secure
(9 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels