Rock-slide-engineering JEEP JK4 STEP SLIDER Manuel d'utilisateur télécharger pdf (Page 6)

Installation Instruction RSEI 106

**WARNING**

REMOVE FUSE FROM WIRING HARNESS PRIOR TO INSTALLATION! CONNECTING

THE HARNESS TO THE POWER SOURCE WITH THE FUSE ATTACHED WILL SHORT

OUT THE WIRING HARNESS

NEVER ALLOW THE DOOR SENSOR TO COME INTO DIRECT CONTACT WITH THE

ACTUATING MAGNET. THIS WILL DESTROY THE SENSOR MAKING IT UNUSABLE

• Remove the “B” pillar covers on both driver and passenger and driver sides

• Roll the carpet back underneath the rear seat to expose the floor boards

• Position the control box under the rear seat on the passenger side

• It’s recommended that you mount the control box under the rear passenger seat

because it’s out of sight and in a secure location so it will not come into contact

with anything or be kicked by a rear seat passenger (see below)

• Plug the harness into the control box and lay the harness wire into position in the Jeep

starting on the rear passenger side

• You will want to divide the harness between the rear seats, the front passenger

seat and finish with the driver door. This will reveal how you will be able to

conceal the harness under the carpet when your done

• Once the harness is positioned in its proposed layout you will need to gain access to the

slider outside the Jeep to power the slider.

• Starting on the rear passenger side, locate the drain plug and drill a small hole into it to

allow you to run the actuator wires to the slider (see below)

• Once the actuator is run to the slider you can put some silicon sealant around

the drilled hole to prevent any elements from entering, but it’s not required

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Rock-slide-engineering JEEP JK4 STEP SLIDER Manuel d'utilisateur Page 6