Rock-slide-engineering JEEP JK4 STEP SLIDER Manuel d'utilisateur

Installation Instruction RSEI 106 JEEP JK4 STEP SLIDER INSTALLATION BD-SS-100-JK4

Installation Instruction RSEI 106 TROUBLE SHOOTING/FRICTION POINTS • The slider is powered by the Jeep’s battery when engine is off and powered by

Installation Instruction RSEI 106 PARTS LIST QTY DESCRIPTION 1 Drivers Side Slider Assembly 1 Passenger Side Slider Assembly 1 Wiring Harness and F

Installation Instruction RSEI 106 STEP SLIDER INSTALLATION 1) Remove the stock rocker guards if equipped 2) Remove the front body bolts on the driv

Installation Instruction RSEI 106 7) Insert the 3 slider forks into the 3 body mount bolt slots a) The slider should fit tight to the Jeep’s rocker

Installation Instruction RSEI 106 16) Lift the slider into its final position by inserting the 3 forks on the slider onto the 3 body mount bolts and

Installation Instruction RSEI 106 **WARNING** REMOVE FUSE FROM WIRING HARNESS PRIOR TO INSTALLATION! CONNECTING THE HARNESS TO THE POWER SOURCE WITH T

Installation Instruction RSEI 106 • Route the actuator wire around the backside of the slider and plug the red/black connector into the slider • Ac

Installation Instruction RSEI 106 • Remove the driver side dash panel and drill a 18mm hole in the panel to accommodate the cutoff switch • You can

Installation Instruction RSEI 106 • Once that proper placement is achieved we recommend using a permanent marker to outline the magnet on the door. •