Rock-slide-engineering TUNDRA SERIES – STEP SLIDER Manuel d'utilisateur télécharger pdf (Page 4)

Installation Instruction RSEI 131

b. With bracket in the correct location, mark the location of the holes with a

marker on the panel of the truck. These will be the locations for the nutserts to

be installed in the body.

6. Carefully drill a 7/32’’ pilot hole into the center of the marked points into the truck’s

rocker side

a. **It is extremely important these holes are drilled precisely to insure the

slider will fit properly once the nutserts have been installed

7. From the center of the pilot hole, step up the hole size using a ½” bit to create a finish

hole that will be used to install the nutserts

8. Install nutserts in the holes that were just drilled into the body of the truck

a. We suggest using a crimping tool to optimize the integrity of the nutserts to

support the slider

b. If no crimping tool is available, follow these instructions

i. Install by using a 5/16’’x1.125’’ minimum length bolt with a 3/8’’ nut

ii. Put a small amount of grease on the bolt to reduce friction

iii. Hold the nut steady with an end wrench so the flange of the insert is flush

against the body panel

iv. Tighten the bolt against the nut to crimp the nutsert into place

v. If the nutsert is rotating, place a star-lock washer between the 3/8’’ nut

and nutsert

vi. Once the nutsert is crimped into place completely back out the bolt

vii. If the nutsert ever breaks loose and spins, repeat the process and crimp it

tighter to prevent spinning

Nutserts properly installed

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Rock-slide-engineering TUNDRA SERIES – STEP SLIDER Manuel d'utilisateur Page 4