Rock-slide-engineering TUNDRA SERIES – STEP SLIDER Manuel d'utilisateur télécharger pdf (Page 10)

Installation Instruction RSEI 131

14. Mount the ground from the cutoff switch to a metal surface behind dash panel

15. Route the cutoff switch wires by running the POS+ and NEG- wires rom the wiring

harness plug them into the back of the cutoff switch

THE BRASS COLORED PRONG IS FOR THE GROUND THE SILVER COLORED IS FOR THE POWER

16. Route the remaining POS+ and NEG- wires through the firewall on the driver’s side into

the engine compartment. YOU MAY NEED TO DRILL A HOLE THROUGH THE FIREWALL

INTO ENGINE COMPARTMENT

a. Make sure there is NO INTERFERENCE with any of the pedal linkage under the

dash

17. Route these wires along the firewall up to the battery compartment

a. Secure the wires using the harness attached to the firewall

18. Attach the NEG- to the NEG- side of the battery

19. Attach the POS+ to the POS+ side of the battery

Possible switch

locations

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

Rock-slide-engineering TUNDRA SERIES – STEP SLIDER Manuel d'utilisateur Page 10