Rock-slide-engineering TJ YJ LJ STEP SLIDER Manuel d'utilisateur télécharger pdf (Page 3)

Installation Instruction RSEI 123

SLIDER INSTALL

1. Remove stock sliders from the Jeep, if equipped.

2. Use a floor jack or buddy to help hold the slider in place in order to mark holes to be

drilled. Take extra care when positioning the slider on the Jeep rocker face to prevent

any scratching or marring of the painted surface. The slider should be tight on the

underside and to the rocker side of the Jeep. Take your time to ensure that the slider is

installed straight and level. Check to make sure that the slider is in the correct position

on the front and rear side, between flares.

3. Mark the side mounting holes on the rocker panel, and on the underside of the tub,

double check for correct fitment. The slider should be tight against the underside and

the rocker side of the body.

4. Remove slider and drill 1/2” holes for nut inserts on the UNDERSIDE. This will

accommodate the larger nut inserts. We suggest using a center punch and a small pilot

drill to precisely drill the center of the hole, for the nut inserts on the side of the body

the hole size needs to be a17/32”. The body sides are very thin metal so let the drill bit

do the work. Don’t push too hard on the drill, possible sheet metal damage may

occur. (don’t over tighten inserts when crimping)

(You will need to add the 3/8” aluminum spacers underneath the back two bolt holes to fill the

gap between the slider and the body of the Jeep)

1 2 3 4 5 6 7 8

Pas de commentaire

Rock-slide-engineering TJ YJ LJ STEP SLIDER Manuel d'utilisateur Page 3