Rock-slide-engineering STEP SLIDER MOTOR REPLACEMENT Manuel d'utilisateur télécharger pdf (Page 1)

Rock Slide Instruction RSEI 122

STEP SLIDER MOTOR REPLACEMENT INSTALLATION

Important

Before installation, make sure control box has a serial number on

the circuit board. Updated control boxes all have serial numbers. In

order to verify, unscrew cover from control box and look for serial

number on the circuit board. New upgraded motors are only

compatible with new control boxes. If your step slider has a control

box without a serial number, it will need to be replaced in order to

work with the new upgraded motor. Replacement updated control

boxes are available for purchase at Rock-Slide Engineering. Call

435-752-4580 for assistance.

1 2 3 4

Page 1

Rock Slide Instruction RSEI 122 STEP SLIDER MOTOR REPLACEMENT INSTALLATION Important Before installation, make sure control box has a seri

Page 2

Rock Slide Instruction RSEI 122 STEP SLIDER MOTOR REPLACEMENT INSTALLATION 1. Remove the Step Slider in order to access the old motor 2. Remove t

Page 3

Rock Slide Instruction RSEI 122 4. Install new motor NOTE: When installed, the motor portion of the actuator (the shorter round cylinder) should b

Page 4

Rock Slide Instruction RSEI 122 d. Screw dummy bolt with nut into hole towards front of slider e. Position back bracket over back hole f. M

Pas de commentaire

Rock-slide-engineering STEP SLIDER MOTOR REPLACEMENT Manuel d'utilisateur Page 1