Rock-slide-engineering JEEP JK2 STEP SLIDER Manuel d'utilisateur télécharger pdf (Page 5)

Installation Instruction RSEI 107

WIRING HARNESS INSTALL

**Note: The same harness is used for the JK 4-door version **

The additional door sensors are NOT used for the 2-door version

Step Slider Wiring Diagram

Driver Side Wire Color Passenger Side Wire Color

Front Door Sensor Orange/Yellow Front Door Sensor Green/Gray

Driver LED Light Brown/Tan Passenger LED Light Pink/Tan

Driver Actuator Red/Black Passenger Actuator Red/Black

**WARNING**

REMOVE FUSE FROM WIRING HARNESS PRIOR TO INSTALLATION! CONNECTING

THE HARNESS TO THE POWER SOURCE WITH THE FUSE ATTACHED WILL SHORT

OUT THE WIRING HARNESS

NEVER ALLOW THE DOOR SENSOR TO COME INTO DIRECT CONTACT WITH THE

ACTUATING MAGNET. THIS WILL DESTROY THE SENSOR MAKING IT UNUSABLE

1. Remove the “B” pillar covers on both driver and passenger and driver sides.

2. Roll the carpet back underneath the rear seat to expose the floorboards.

3. Position the control box under the passenger seat.

a. It’s recommended that you mount the control box, but it’s not required

b. Be sure the control box is out of sight and in a secure location so it will not come

into contact with anything or be kicked by a rear seat passenger

4. Plug the harness into the control box and lay the harness wire into position in the Jeep

starting on the passenger side.

a. You will want to divide the harness between the driver and passenger side to get

an idea of how you want to divide and conceal the harness under the carpet

1 2 3 4 5 6 7 8 9

Pas de commentaire

Rock-slide-engineering JEEP JK2 STEP SLIDER Manuel d'utilisateur Page 5